Thoroughly sand in the direction of the grain to remove all traces of old finishes and dirt, oil and contamination. Old floors can be impregnated with wax and grease – this will cause failure and must be completely removed. On new wood or if the old finish is in good condition, lightly sand to provide a key. Thoroughly clean after sanding.
Ensure the product is well mixed. Apply 3 coats of varnish. On new wood and porous surfaces dilute the first coat 10% with water. Lightly sand wood in between applications to remove any raising of the grain that may have occurred.
When using dead flat finish, if a very high level of durability and stain resistance is required, apply one or two coats of Heavy Duty Floor Varnish Satin Finish followed by one or two coats of Heavy Duty Floor Varnish Dead Flat Finish.
Always apply to a test area before starting work. Appearance may vary according to the colour and type of wood and the number of coats.
Do not apply over uncured oil paints.
Protect from extremes of temperature during storage and application. Do not use below 5 degrees C.
health, safety and the environment
Non-hazardous. Ensure good ventilation.
Keep out of reach of children.
Contact with eyes – wash immediately with warm water.
Remove excess from tools and mixing vessels before washing in warm soapy water.
Do not empty into drains or watercourses.
wooden floors • cork tiles • stone • slate • brick • quarry tiles • wooden worktops
available in: • 1 litre • 2 litre
drying time: 30-60 minutes • recoat time: 1-2 hours • curing time: 16 hours in ideal conditions. Allow 48 hours before heavy use. • coverage: 10-20 square metres per litre